ASTM F – Standard Specification for Pressure-rated Polypropylene (PP) Piping Systems. CSA B – Polypropylene (PP-R) Pipe and Fittings for. ASTM F “Pressure-rated Polypropylene (PP) Piping Systems”. Presented to the IAPMO Standards Review Committee on May 8, General: The. Find the most up-to-date version of ASTM F at Engineering
|Published (Last):||20 July 2015|
|PDF File Size:||12.14 Mb|
|ePub File Size:||14.90 Mb|
|Price:||Free* [*Free Regsitration Required]|
It is the responsibility of the user of this standard to establish appropriate safety and health practices g2389 determine the applicability of regulatory requirements prior to use.
Included are criteria for materials, workmanship, dimensions and tolerances, product tests, and marking for polypropylene PP piping system components such as pipe, fittings, valves, and manifolds. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application.
Link to Active This link will always route to the current Active version of the standard. Historical Version s – view previous versions of standard. ASTM does not give any warranty express or implied or make any representation that the f3289 of this abstract are accurate, complete or up to date.
When tested according to the procedures provided herein, the piping components shall adhere to specified requirements for workmanship, dimensions, longitudinal reversion, melt flow rate, impact resistance, thermal stability and oxidative induction time OIThydrostatic pressure, t2389, and oxidative stability in potable chlorinated water. The f289 shall consult the manufacturer to determine whether the material being transported is compatible with the polypropylene piping system and will not affect the service life beyond limits acceptable to the user.
ASTM F – 17a Standard Specification for Pressure-rated Polypropylene (PP) Piping Systems
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. This specification establishes the requirements for polypropylene PP piping system components such as pipe, fittings, valves, and manifolds used in water service lines, hot-and-cold water distribution, hydronic heating, and irrigation systems to transport industrial process fluids, effluents, slurries, municipal sewage, etc.
The piping system components covered here are made to metric sizes and IPS schedule 80 sizes, and zstm rated for water service and distribution supply. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
This abstract is a brief summary of the referenced standard.
Work Item s – proposed revisions of this standard.